Samson DOUBLE BRAID Class II Eye Splice Modified for TS-II and TS-II Premium - Manual (Page 3)

PAGE 3 OF 5
SamsonRope.com | Email [email protected] | Tel +1.360.384.4669
Double Braid Class II Eye Splice Modified for TS-II and TS-II Premium
S A M S O N S P L I C I N G I N S T R U C T I O N S
From Mark 2 on cover, count 8 picks
(pairs of right and left laid strands) in the
direction of Mark 1 and make Mark T.
Extract core from cover at Mark T and
pull completely free.
4 b
After the control core has been pulled completely free,
cut off the excess approximately 1 foot from where
it protrudes from the primary core.
5
step
5 A
Cut cover at Mark 1. Starting at Mark
T on the side of the cover opposite
from the core extraction point, mark
every other right and left laid strand
pair for a distance of 5, 6, or 8 pairs,
depending on rope diameter (1/2"
through 5/8" diameter, mark 5 pairs,
3/4" through 1-1/2" diameter, mark
6 pairs. 1-5/8" diameter and above
mark 8 pairs.)
Mark a
Mark c
Mark B
Cut off excess control core
8 picks
Mark 2 Mark t
Cut cover at Mark 1
Mark 1
Mark 2
Mark 2
Mark t
ta p e r i n g t h e c o v e r
5 b
Reduce cover tail to 1/2 volume by
cutting and removing the marked
strand pairs. Milk cover from pin
placed between Marks 2 and 3
towards exit point of core tail. Make
Mark D on the core at its exit point.
From Mark D, measure down the
core a distance of 2/3 fid length, and
make Mark E.
Mark t
Mark 2
Mark d Mark e
2/3 fid