Samson DOUBLE BRAID Class II Eye Splice Modified for TS-II and TS-II Premium User Manual

Page 5

Advertising
background image

PAGE 5 OF 5

SamsonRope.com

| Email

[email protected]

| Tel

+1.360.384.4669

Double Braid Class II Eye Splice Modified for TS-II and TS-II Premium

S A M S O N S P L I C I N G I N S T R U C T I O N S

8

Pull end of core tail to expose approximately 2/3 fid

length of core tail. Remove fid and all tape from end of

tail. From end of core tail, count 3 strands and mark a

right and a left strand. From marked strands, count 4

strands and mark a right and left strand. Alternately mark

third right and left strands then 4th right and left strands

until a total of 5 right and left pairs have been marked.

Taper core by cutting and removing marked strands.

step

9

With rope positioned as shown, milk core loop away

from pin, working slack beyond Mark B where control

core exits primary core. Hold core loop as shown and

pull sharply. This will set the position of the control

core and cause the core tail to disappear inside the

core loop. Repeat milking and pulling until all slack is

removed from core loop.

step

Mark 3

core tail end

Mark 2

3rd

4th

3rd

4th

3rd

Mark B

control core

Milk

Tapered

core tail

ta p e r i n g t h e c o r e

f i n i s h i n g t h e s p l i c e

9

A

Mark control core right where it exits the core

loop. Pull control core out slightly, then cut

off just short of the mark. Repeat previous

step one final time to seat control inside of

core loop. Remove the pin.

9

b

Create tension on core loop by pulling on it with one hand,

then begin to milk cover up over splice area with other

hand. On larger sizes, mechanical tension may be required.

Continue cover milking until Marks 2 and 3 come together.

9

c

After the cover is completely milked and the core loop is fully buried, there

may be a small loop of core material protruding from the cover at Mark 3.

Milk the cover around the eye towards the core material and pull sharply

on eye. Excess core material should disappear inside of eye.

Pull

Finished Splice

Mark 3

Mark 2

control

core

Tapered

core tail

Milk cover

DOCUMENT Double_Braid_C2_Eye_Splice_TS-II.pdf

© 2012 Samson Rope Technologies, Inc. All rights reserved.

S/WD #108294 7/2012

Advertising