SONiVOX Twist - Manual (Page 26)

26
Automation
Many of Twist's parameters can be automated inside your DAW. This section has a few tips
about automating Twist. If you haven't used automation in your tracks before, though, consult
your DAW's reference manual for specific instructions on automating plug-in parameters.
When automating Twist parameters, select the desired parameter from the list of Twist's
automation parameters and either draw the automation in with your mouse or use a hardware
controller to record it. When you start playback, you will see Twist's parameters change in the
interface in real time.
You can automate the following parameters:
Ch. 1 Intensity Ch. 2 Intensity Master Volume Filter Q
Ch. 1 On-Off Ch. 2 On-Off Mod Wheel Filter Envelope Parameters
Ch. 1 Pitch Ch. 2 Pitch Pitch Bending Amp Envelope Parameters
Ch. 1 Tune Ch. 2 Tune LFO Shape All Delay Parameters
(except tempo sync values)
LFO Depth
LFO Frequency Rate All Chorus Parameters
LFO Sync Rate All Reverb Parameters
Tip: If you have a hardware controller that sends MIDI continuous control (CC) messages, you
can assign them to control your effects' parameters in real time. Simply assign these knobs to a
CC, and record automation as you would any other parameter. (See the MIDI Learn section for
more information.) It's common to use a combination of recording and drawing the automation
in your DAW to get a good feel or to edit things after you've recorded them.