Chicago Electric Battery Charger with LCD Display 65834 - Manual (Page 7)

SKU 65834 For technical questions, please call 1-800-444-3353. Page 7
Display Features:
Power Switch: 1. Press “ON/OFF”
to start charging. Press “ON/OFF”
again to stop charging.
(See Figure A.)
Charging Rate Selection:
2. Press
“AMPS SELECTION” button to set
charging current. (See Figure A.)
LCD Display of Charging Current: 3.
The LCD will indicate charging cur-
rent (2 Amp, 4 Amp, 6 Amp, or Auto)
that has been selected.
(See Figure A.)
FIGuRE A
BATTERY
SELECTIOn
CHARGInG
SPEED
SELECTIOn
POWER
SWITCH
LCD DISPLAY
FEATuRInG:
* CHARGInG CuRREnT
* BATTERY TYPE
* BATTERY STATuS
* SOunD ALARm
* VOLTAGE
* ERROR SIGnAL
POSITIVE (+)
BATTERY CLAmP
nEGATIVE (--)
BATTERY CLAmP
Error Signals:
Under 1. improper polarity, the LCD will
display “E01”. (See Below.)
If battery is 2. disconnected during
charging, the LCD will display “E02”.
(See Below.)
Battery Selection: 4. Press “6V or
12V” for the battery type that is to be
charged. (See Figure A.)
LCD Display of Battery: 5. The LCD
will indicate the battery type (6V or
12V) that has been selected. (See
Figure A.)
LCD Display of Voltage:
6. Before
connecting the battery, the LCD will
display “00.0V”. After connecting
the battery, the LCD will display the
battery voltage. During charging, the
LCD will display the charging voltage.
(See Figure A.)