Tri-Tronics Multi Sport 3 - Manual (Page 5)

QUICK GUIDE
Before You Start…
1. Install the collar strap(s) (page 7).
2. Install the transmitter antenna (page 8).
3. Charge collar battery for 14 hours (page 18).
The transmitter is shipped with one replaceable
9-volt battery already installed.
Using the Remote Trainer
1.
Turn the collar on: Set the intensity dial on 0 (zero).
Hold the transmitter within 10 feet of the collar and
hold a button down for about 5 seconds. The collar
light double-blinks to confirm it is turned on. (A rapid
blink means that collar batteries are low.) Once the collar
is turned on, move the intensity dial to a setting other
than 0 (zero) for training, To turn the collar off, repeat
the turn-on process.
2. Fit the collar on the dog: Fasten the collar strap
midway between dog's ears and shoulders, and buckle
snugly. The collar light should face towards the dog’s
nose. Do not leave a collar on a dog continuously.
See page 11.
3. Select an intensity level for training: Level 1/2 is the
lowest; level 5 is the highest. Release the transmitter
button when changing levels during training. Intensity
selection tips are in your training manual and video.
4. Transmitter buttons:
Sport 50: Black button – momentary stimulation.
Red button – continuous stimulation.
Sport 60: Same as Sport 50 with addition of green
button for audible tone.
Sport 65 BPR: Same as Sport 50 with addition of orange
button to turn the Beeper on and off.
Multi•Sport 2: Green button – continuous stimulation
from collar with green strap. Orange button – continuous
stimulation from collar with orange strap.
Multi•Sport 3: Same as Multi•Sport 2 with addition
of yellow button for continuous stimulation from
collar with yellow strap.
T R I - T R O N I C S
Q u i c k G u i d e
Quick Guide Page 1