Tri-Tronics G2 Tri-Tronics® Beeper - Manual (Page 2)

The Tri-Tronics Beeper
The Tri-Tronics Beeper lets you know where your bird dog is hunting and when
he goes on point. The Beeper has a wide choice of settings to suit different hunting
styles and individual preferences. You can also keep track of several dogs at one
time by the settings you select.
If you purchased an Upland G2 or Sport ® 65 BPR G2, your Beeper can be turned
on and off from a distance with your transmitter. Therefore, you can leave the
beeper off most of the time, and only turn it on when hunting conditions require it.
If you own any Tri-Tronics G2 Field or Pro Series model, you can also use your
transmitter to turn the Beeper on or off from a distance. If you own any other
make or model of remote trainer or you plan to use the Beeper by itself with no
remote trainer, you cannot turn your Beeper on or off from a distance, but your
Beeper will have all other functions.
Quick Guide
1. Beeper battery.
One 9-volt alkaline battery is already installed. When it is time to change the
battery, install it in the correct direction and do not force a battery into the
compartment.
2. Beeper modes.
You have a choice of volume, range/point or point-only modes, four run tones,
and two point tones. To change the preset modes, move the DIP switches inside
the battery compartment.
3. Collar strap.
The Beeper is designed to be installed on a Tri-Tronics product collar strap or on
any other Remote Trainer having a 1-inch collar strap that fits the Beeper. The
Beeper will ride best on the dog's neck if you use a remote training collar or
dummy collar to counterweight the Beeper.
4. Beeper power switch.
The Beeper power must be on for the Beeper to operate and for the remote on/off to
operate. Press the round power switch located on the rear surface of the Beeper.
You will hear two tones and the Beeper light will begin flashing. The Beeper will
begin beeping as soon as its power is turned on. To save Beeper battery life, turn
the power switch off after use. If you want the Beeper to be silent until you begin
hunting, turn it off with your Upland G2 or Upland G2 EXP, Sport Upland™ G3
or Sport
® 65 BPR G2, or with any other Tri-Tronics G2 Field or Pro
Series transmitter.
5. Beeper fit.
Buckle the Beeper snugly on the dog with the Beeper on top of the dog's neck.
The power switch should face towards the dog’s tail.
6. Training collar turned on.
(Tri-Tronics models with remote Beeper activation) The collar must be activated for
you to be able to turn your Beeper on and off remotely. The transmitter intensity
dial must be set as described in #7 and #8.
7. Remote turn on/off.
(Upland G2 and Upland G2 EXP, Sport Upland™ G3 and Sport
® 65 BPR G2)
Pressing the beeper control button turns the Beeper on or off from a distance.
Tones confirm “on” and “off.”
See the section “Beeper Control Button” for the location of this button for your
model. Note that the transmitter intensity dial must not be on “N” or “T.”
8. Remote turn on/off:
All other Tri-Tronics G2 and G2 EXP Field and Pro Series models. Pressing any
transmitter button turns the Beeper on or off from a distance. Tone confirms “on”
and “off.” Note that your dial must be set on “A.”