Tri-Tronics G2 Tri-Tronics® Beeper - Manual (Page 4)

2. Set the DIP switches.
Hold the Beeper so that the switches are on the top
edge of the compartment. You do not need to turn
the Beeper off to change the settings or to make the new
settings take effect. The switch is indicated by the dark
in the diagram section
To select your settings, set the switches in the positions
shown in the diagram below. All switches except the
volume switch make a confirming “chirp” when their
positions are changed. Replace the battery cover when done.
Installing or Changing the Beeper Battery
Open the battery compartment, as described in “Changing Beeper Settings.”
Install a Panasonic, Duracell or Eveready 9-volt alkaline battery. The battery can
only be installed in the correct direction. Note that some other battery brands will
be too long and will not fit correctly. Never force a battery into this compartment.
Installing and Adjusting the Beeper on a Collar Strap
The photos below show how to install the Beeper on a collar strap. Adjust the
position of your Beeper on the strap for the size of your dog. It should ride
directly across from the remote training collar when placed on your dog, with
the Beeper on the top of the dog's neck and the collar underneath his neck.
The collar strap may be cut off to fit your dog’s neck. Never cut the strap until
both the Beeper and remote trainer are installed on the strap.
9-volt battery
DIP Switches
When setting switches,
hold the Beeper as shown
1 2 3 4 5
Low High
Range/Point Point-Only
Single Beep Double Beep Triple Beep Tracking Tone
Single Tone Hawk Scream
Volume Switch:
Modes:
Run Tones:
Point Tones:
1 2 3