Sony CDP-C77ES - Manual (Page 13)

You can make a program by designating up to 32
seiections in the order you want them to be played. The
unit will play the disc according to your program.
You can make a program for both sides (side A and side
B) of the tape at one time.
You can program one selection or one disc in a step.
To play the selection for side B
When the selections for side A have been played, the unit
will pause. (“B” will light up.)
Set the tape to the beginning of side B, then press ^ or
II. The selections for side B will start playing.
Adding selections to a program during program play
1 Press the desired disc button while the unit is in №e
play or pause mode.
2 While the step display appears, press the TRACK
buttons which correspond to the selection number you
want to add.
To stop program play
Press ■. The last selection number programmed is
displayed.
To resume play, press Play begins from the beginning
of the program.
You can play the same program repeatedly as long as you
do not cancel program play or erase the program.
To cancel program play
Press CONTINUE and return to the continuous playing
mode. The program will be erased.
Skipping to the next selection programmed
Press during play.
Gohtg beOi to the beginning of the aelechon being played
Press M4 during play.
DIaplay on atep 3 (procedure atep diaplayf:
HI
(!i!l
qr.
BL BO.! B
Checking the Programmed
Selections
Press CHECK
The disc, track, and program numbers of the first selection
in your program will be displayed.
Each time you press CHECK, the next selection in the
program will be displayed.
When CHECK is pressed after the last selection, END
appears and then the display returns to the initial display.
Clearing the Programmed
Selections
Clearing the whole program
Press ■ once during stop, or twice during play.
All the selections will be cleared.
Clearing the last selection in a program
Press CLEAR during stop.
The last selection will be cleared each time CLEAR is
pressed.
Clearing a specific seiection
1 Press CHECK repeatedly until the selection to be
cleared is displayed.
2 Press CLEAR while the selection number is displayed.
The selection will be cleared from the program.
The whole program wW afso be cleared hi the foHoerlng
situations
•ft is pressed.
• Power is turned off.
• Select other play modes.
To check the atep of prognunmed aelectlona
Press TIME/MEMO during stop mode.
The number of programmed selections will be displayed for few
seconds in the window.
To check the remaining time of the selection being played
Press TIME/MEMO once to see the remaining time of the
selection being played; twice to see the disc memo or disc
number; three times to return to the initial display.
The total remaining time cannot be displayed.
If you have programmed a selection number over 20, —.— is
di^ayed instead of the remaining time.
Note
When selections have been programmed for sides A and B, the
total playing time displayed during stop nrode will show the
selections programmed for side B and the total playing time for
side B.
13