Sony CDP-C77ES - Manual (Page 28)

Connect Two Players and for More Listening
Enjoyment - Serial Chain Controi (CDP-C87ES only)
Amplifier
[olol To, roTol foTo j [cTo]
^oIoT W
dZT
Il o olo o
1
O olo O
1
=
Player 1
2—
Playera
Connect
Player 1
M ode
Player 2
Disconnect
28
The serial chain control feature allows you to play from
two different piayers. You will need another CD player that
supports the serial chain function.
The following three modes are available.
CHAIN mode - Each player takes turns playing either
RELAY mode-After all discs in the first player have been
played, the discs in the second player are
played.
OFF mode- Disables the serial chain mode to play
either player alone.
CHAIN RELAY
Continuous
play
Bank play
Each player takes
turns playing one
complete at a time.
After all discs in player
1 (or 2) are played, the
discs in player 2 (or 1)
are played.
Shuffle play
Select shuffle
play
Each player takes
turns pla^ng discs.
Discs are exchanged
after playing all
shuffled selections on
that disc.
After alt discs in player
1 (or 2) are play^, all
the discs in player 2
(or 1) are played.
Program play Not available in the
chain mode.
After all selections
programmed (or stored
in the bank) (or player
1 are played, all the
selections programmed
(or stored in the bank)
for player 2 are played.
Repeat play is available with serial chain operation.
However, you can repeat a single selection in the
continuous play mode.
Notes
•
The 1 DISC mode is not available in the serial chain mode.
• Music scan will only work with one player.
To Connect
Be sure both players are turned off before connecting
them.
1 Turn the power off to both piayers.
2 Connect the players with the serial chain cable supplied
with either player.
3 Set the SERIAL CHAIN CONTROL MODE selector
switch on piayer 1 to 1. Set player 2 to 2.
To use the CONTROL S feature, connect as follows.
Amplifier or receiver This unit dSdn*eature*'
a m ±1 9) □
CONTROLS o I j T CONTROLS llil ¿ONTRaSOUT 1
Notes
•
The LINE OUT Signal to your amplifier can be connected to the
FIXED or VARIABLE jack on either player 1 or player 2.
• Audio optical connecting cord cannot be used to connect both
players. Set the function mode on your amplifier to ANALOG IN.