Installing the cd player ■ maintenance, Notes on installation, Cleaning the cabinet – Sony CDP-C77ES User Manual

Page 4: Cleaning discs, On safety, On operation, Precautions

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

Installing the CD Player ■ Maintenance

Notes on Installation

Cleaning the cabinet

Place the unit in a iocation with adequate air circuiation

to prevent internal heat build up in the unit.

Do not place the unit on a soft surface, such as a rug

that would block the ventilation holes on the bottom.

Do not install the unit.

- near heat sources such as radiators or air ducts.
- in a place subject to direct sunlight, excessive dust,

mechanical vibration or shock.

Use on level surface. Make sure that the unit is placed

in a proper location before switching the power on.

Do not transport the unit with the discs inserted.
If you remove the side panels to install the unit in a

rack, be sure to secure the metal casing with the

supplied screws (M3x8 mm in length). DO NOT use the
longer screws that held the side panels in place.

On moisture condensation

If the player is brought directly from a cold to a warm

location, or is placed in a very damp room, moisture

may condense on the lens inside the unit. Should this

occur, the player will not operate. In this case,

remove the disc and leave the player turned on for

about an hour until the moisture evaporates.

Clean the cabinet, panel and controls with a soft cloth
lightly moistened with mild detergent solution. Do not use
any type of abrasive pad scouring powder or solvent such
as alcohol or benzine.

Cleaning discs

Before playing, clean the disc with the cleaning cloth.
Wipe the disc from the center out.

Do not use solvents such as benzine, thinner,

commercially availeible cleaners or anti-static spray
intended for analog discs.

After playing, store the disc in its case.

Precautions

On Safety

Check the unit’s operating voltage before operation. It

must be identical with that of your local power supply.
The operating voltage is indicated on the nameplate at
the rear of the unit.

• Should any liquid or solid object fall into the cabinet.

Unplug the unit and have it checked by qualified
personnel before operating it any further.

• Unplug the unit from the wall outlet if it will not be used

for a long time. To disconnect the cord, pull it out by
grasping the plug. Never pull the cord itself.

• As the laser beam used in this compact disc player is

harmful to the eyes, do not attempt to disassemble the
cabinet. Refer servicing to qualified personnel only.

On operation

When the unit is not used, turn the power off to conserve
energy ¿md to extend the useful life of your unit

Important

Since the CD system boasts a wide dynamic range, the
peaks of high level inputs are recorded with high
fidelity, and the noise level is very low.

Do not turn up the volume while listening to a portion

with no audio signals or very low level inputs if you do,
the speakers may be damaged when a peak level

portion is played.

For detailed safety precautions, see the leaflet
“IMPORTANT SAFEGUARDS”.

If you have any questions or problems concerning your
unit please contact you nearest Sony dealer.

Advertising