Sony KV-27V22 - Manual (Page 23)

fMI Operating a cable box or DBS receiver
Programming the remote
You can program the supplied remote control
to operate a cable box or DBS receiver.
1
Press CODE SET.
2
Press DBS/CABLE (FUNCTION).
3
Use the 0-9 buttons to key in the
manufacturer's code number from the
following chart.
4
Press ENTER.
To operate the TV
Press TV (FUNCTION). Then use the TV
control buttons to control the TV.
For more details on operating the
cable box or DBS receiver
Refer to the operating instructions that come
with the equipment.
If the remote control doesn't work
• First, try repeating the set up procedures
using the other codes listed for your
equipment.
T i p s
• If more than one code number is listed, try entering
them one by one until you come to the correct code for
your equipment.
• If you enter a new code number, the code number you
previously entered at that setting is erased.
• In some rare cases, you may not be able to operate
your equipment with the supplied remote control. In
this case, use the equipment's own remote control
unit.
• Whenever you remove the batteries — to replace
them, for example — if too much time is taken, the
code numbers may revert to the factory setting and
must be reset.
Manufacturer code numbers
(cable box)
Manufacturer Code number
Hamlin/Regal 222, 223, 224, 225, 226
lerrold/G. 1. 201, 202, 203, 204, 205, 206,
207,208, 218
Oak 227, 228, 229
Panasonic 219,220,221
Pioneer 214,215
Scientific Atlanta 209,210,211
Tocom 216, 217
Zenith 212,213
Manufacturer code numbers
(DBS receiver)
Manufacturer Code number
Sony 801 (preset code for
remote control)
GENERAL ELECTRIC 802
RCA/PROSCAN 802
20