Sony SLV-662HF - Manual (Page 6)

Controlling other TVs with the remote commander
The remote commander is preprogrammed to control non-Sony TVs. If your
TV is listed in the table below, set the appropriate manufacturer's code
number.
1
Set [Tv]/1 VIDEO at the top of the remote commander to |TV|.
2
Hold down l/(i), and enter your TV's code number(s) using the number
buttons. Then release l/(l).
Now you can use the l/(i), VOL + /-, CH + /- and TV/VIDEO buttons to
control your TV. You can also use the buttons marked with a dot («) to
control a Sony TV. To control the VCR, reset |TV
I/ 1 VIDEO I to IVIDEOl.
Code numbers of controllable TVs
If more than one code number is listed, try entering them one at a time until
you find the one that works with your TV.
step 2: Setting up the remote commander (continued)
Manufacturer Code
number Manufacturer Code
number Manufacturer Code
number
Sony 01 JVC 09 RCA 04, 10
Akai 04 KMC 03 Sampo 12
AOC 04 Magnavox 03, 08, 12 Sanyo 11
Centurion 12 Marantz 04, 13 Scott 12
Coronado 03 MG A / Mitsubishi 04,12, 13,17 Sears 07, 10,11
Curis-Mathes 12 NEC 04, 12 Sharp 03, 05, 18
Daytron 12 Panasonic 06, 19 Sylvania 08,12
Emerson 03, 04, 14 Philco 03,04 Teknika 03, 08, 14
Fisher 11 Philips 08 Toshiba 07
General Electric 06,10 Pioneer 16 Wards 03, 04, 12
Gold Star 03, 04, 17 Portland 03 Yorx 12
Hitachi 02,03 Quasar 06, 18 Zenith 15
J.C.Penny 04, 12 Radio Shack 05, 14
Notes
• If the TV uses a different remote control system from the one programmed to work
with the VCR, you cannot control your TV with the remote commander.
• If you enfer a new code number, the code number previously entered will be erased.
• When you leplace the batteries of fhe remote commander, the code number may
change. Set the appropriate code number every time you replace the batteries.
• When you press the AUDIO MONITOR button, your TV's menu may appear on the
TV screen. To exit the TV menu, press the MENU button on the TV remote
commander or wait until the menu disappears automatically.
Cpttinn Started