Adjusting the picture, Adjusting the tracking, Tracking meter – Sony SLV-662HF User Manual
Page 64: About the adaptive picture control (apc) function, Apc playback, Apc recording, Notes
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Adjusting the picture
Adjusting the tracking
Although the VCR automatically adjusts the tracking when playing a tape
(the 0 indicator flashes in the display window, then goes off), distortion
may occur if the tape was recorded in poor condition. In this case, manually
adjust the tracking.
Press TRACKING +/ - to display the tracking
meter. The distortion should disappear as you
press one of the two buttons (the g indicator
lights up). To resume automatic tracking
adjustment, eject the tape and reinsert it.
Tracking meter
About the Adaptive Picture Control (APC) function
The Adaptive Picture Control (APC) function automatically improves
recording and playback quality by adjusting the VCR to the condition of the
video heads and tape. To maintain better picture quality, we recommend
that you set APC to ON in the ADVANCED OPTIONS menu (with the APC
indicator in the display window lit). For details, see page 64.
APC playback
The APC function automatically works on all types of tapes, including rental
tapes and tapes that were not recorded with APC.
APC recording
Whenever you insert a tape and first start recording, the VCR adjusts to the
tape using the APC function (the APC indicator flashes rapidly). This
adjustment is retained until the tape is ejected.
Notes
• Auto tracking adjustment cannot be guaranteed to work with tapes recorded in LP
mode on other VCRs.
• The APC function does not work if the tape speed is automatically changed from
the SP to EP mode during a timer recording when AUTO TAPE SPEED is set to ON
in the ADVANCED OPTIONS menu, unless the tape has been recorded in the EP
mode with the APC function.
• There is a delay of about ten seconds before the VCR actually starts recording while
the VCR analyzes the tape. To avoid the delay, first set the VCR to recording pause
(the APC indicator flashes slowly) and press • REC to have the VCR analyze the
tape (the APC indicator flashes rapidly). After the APC indicator stops flashing,
press II PAUSE to start recording immediately.
If you want to start recording quickly without using the APC funchon, first set the
VCR to recording pause (the APC indicator flashes slowly) and press
I I
PAUSE to
start recording.
Additional Operations
I
63