Sony STR-GX700ES - Manual (Page 12)

Listening toAA/atching a Program Source (continued)
Operating One Component While Using
Another Changing the Factory Setting of a FUNCTION
Button
You can temporality operate other components while
listening to or watching a program.
Numeric
buttons
BACKGROUND
1 Hold down BACKGROUND.
2 Press both the corresponding numeric button of the
component you're going to use (see the table below) and
one of the following buttons at the same time; VISUAL
POWER, TV/VIDEO, CH PRESET +/-, ANT TV/VTR,
D.SKIP, ► ,
■ , ◄ ◄ /► ► , /► ► !, II, •.
Example: To start recording on a tape deck while
listening to a CD
While holding down BACKGROUND, press
4 (or 5) and press • at the same time.
The numeric buttons are assigned to select the functions
as follows;
Numeric button Operates
1 CD player
DAT deck
MD deck
Tape deck A
Tape deck B
LD player
VCR (remote control mode VTR V)
VCR (remote control mode VTR 2*)
VCR (remote control mode VTR 3*)
TV
Sony VCRs are operated with a VTR 1,2 or 3 setting.
These correspond to Beta, 8mm and VHS respectively.
If the factory settings of the FUNCTION buttons don't match
your system components, you can change them. For
example, if you have two CD players and you don't have a
DAT or an MD recorder, you can assign the DAT/MD
button to your second CD player.
Note that the settings of the TUNER and PHONO buttons
cannot be changed.
Numeric
buttons
SYSTEM
CONTROL/
FUNCTION
1 Holding down the SYSTEM CONTROL/FUNCTION
button whose function you want to change (DAT/MD,
for example).
2 Press the corresponding numeric button of the
component you want to assign to the SYSTEM
CONTROL/FUNCTION button (I - CD player, for
example).
For the numeric buttons, see the table in "Operating One
Component While Using Another."
Now you can use the DAT/MD button to control a
second CD player.
To reset the setting to the factory setting
Repeat the above procedure.
12