Sony CCD-TR66 - Manual (Page 32)

Tips for Using the Battery Pack
When the remaining battery indicator reaches the lowest point, the indicator appears
and starts flashing in the viewfinder.
When the i indicator in the viewfinder disappears and the battery lamp flashes rapidly,
turn the POWER switch to OFF on the camcorder and replace the battery pack. Leave
the tape in the camcorder to obtain smooth transition between scenes after the battery
pack has been replaced.
Note on the remaining battery indicator
The remaining battery indicator of the camcorder may indicate a different remaining
capacity from that of the battery pack with the remaining battery indicator (not
supplied). The indicator of the battery pack is more accurate.
Notes on the Rechargeable Battery Pack
Caution
Never leave the battery pack in temperatures above 140°F (60°C), such as in a car
parked in the sun or under direct sunlight.
The Battery Heats Up
During charging or recording, the battery pack heats up. This is caused by energy that
has been generated and a chemical change that has occurred inside the battery pack.
This is not cause for concern and is normal.
Battery Pack Care
• Remove the battery pack from the camcorder after using it, and keep it in a cool place.
When the battery pack is installed to the camcorder, a small amount of current flows
to the camcorder even if the POWER switch is set to OFF. This is shortens battery life.
• The battery pack is always discharging even when it is not in use after charging.
Therefore, you should charge the battery right before using the camcorder.
How to Use the Switch on the Battery Pack
When the switch is supplied with the battry pack ([a] on p. 33) you can use it to find
whether the battery pack is charged or not. Set the switch to the "no mark" position
when charging is completed. Set the switch to the "red mark" position when the battery
is used up (or in whichever direction you want to remind yourself).
The Life of the Battery Pack
If the battery lamp flashes rapidly just after turning on the camcordrer with a fully
charged battery pack, the battery pack should be replaced with a new fully charged one.
Charging Temperature
You should charge batteries at temperatures from 50“F to 86°F (from 10°C to 30°C).
Lower temperatures require a longer charging time.
Sony Batteries are Recommended
Use of non-Sony batteries may damage your Handycam camcorder.
32