Important, Use the battery completely before rechargingl, Removing the battery pack – Sony CCD-TR400 User Manual
Page 7: Notes on charging the battery pack
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Important!
Use the battery completely before rechargingl
Before you recharge the battery, make sure the battery has been used up (discharged) completely.
Repeated charging while some capacity remains causes a lowering of battery capacity. However, the
original battery capacity can be recovered if you use the battery completely and charge it fully again.
To use up the battery, remove the cassette and slide the POWER switch to CAMERA with the battery
attached, and leave the camcorder until the indicator and the red lamp flash rapidly in the
viewfinder.
I
9
&
0»
i.
Removing the Battery Pack
Slide the battery pack in the direction of the arrow.
I
I
I
i
Notes on charging the battery pack
• The POWER lamp will remain lit for a while even if the battery pack is removed and the power cord
is unplugged after charging the battery pack. This is normal.
• If the POWER lamp does not light, set the selector to the center position emd disconnect the power
cord. After about one minute, reconnect the power cord and set the selector to CHARGE again.
• You cannot operate the camcorder using the AC power adaptor while charging the battery pack.