Sony GV-300 - Manual (Page 16)

Watching TV Programs
‘ft) mute (turn off) the ptoture
Press LCD ON/OFF button.
The screen will be muted.
It is recommended to mute the picture when you view
the playback picture with another TV or monitor. The
picture noise of the TV or monitor is reduced. Battery
life will also last longer if you use the unit with the pic­
ture turned off. To restore the picture on this unit, press
LCD ON/OFF again.
When no picture is displayed and the volume is low, or the earphones are connected, the unit ap­
pears to be turned off even though it is not. Be sure to turn off the unit with the POWER switch
when it is not in use.
1b display the channel nund>er
Press the DATA SCREEN button.
To make the on-screen display disappear, press the
DATA SCREEN button again.
After the SEEK button is pressed, the VHF or UHF
channel range is displayed instead of the channel
number, then goes off after a few seconds.
Channel number
“Last channel" memory function
• While you are watching TV programs, if the power source is disconnected or the battery pack
becomes exhausted, the unit turns off with the last channel being memorized.
When you turn on the unit again, the last channel appears on the screen.
The lithium battery must be installed for this function.
• The last channel memory function also works when the TV signal is cut off, for example, when
you go through a tunnel in a moving car.
• If the lithium battery becomes exhausted but the power source is connected, the last channel
memory function will still operate.
30
Listening to Stereo Programs
Connect the supplied stereo earphones to the PHONES jack to listen to the stereo sound.
The speaker of this unit is monaural.
Normally set the AUTO STEREO ON/OFF
switch to ON.
The STEREO lamp lights up automatically
whenever a stereo program is received.
If excessive noise Is heard when receiving a stereo program
Set the AUTO STEREO ON/OFF switch to OFF. The sound will be
monaural, but the noise will be reduced. In this case, the STEREO
lamp goes off. It is recommended to use monaural sound when us­
ing the unit in a moving car. To restore the stereo sound, set the
switch to ON.
31