Clarion RS10 User Manual
Page 12
9
©
2006 Directed Electronics—all rights reserved
operation.
3.
Once the vehicle has started, it will run for the pre-program-
med period of time (12, 24, or 60 minutes) or until a shut-
down input is triggered. This can be set to minute increments
by your installer.
When you are ready to drive the vehicle:
1.
Insert the ignition key and turn it to the ON
(not the START) position.
2.
Press the brake pedal.
NOTE: If the brake pedal is pressed before the key is
in the ON position, the engine will shut down.
While the vehicle is running during remote engine start operation,
the system will monitor the vehicle and will automatically shut
down the engine if the system receives any of the following shut-
down inputs:
■ The brake pedal is pressed.
■ The hood is opened.
■ The shutdown toggle switch is put into the ON position.
■ The pre-programmed run time has elapsed.
■ The
button is pressed twice within 3 seconds.