Clarion RS10 User Manual
Page 15
12
©
2006 Directed Electronics—all rights reserved
To turn the rear defogger output ON:
1.
Simultaneously press & release the
+
+
buttons
on the remote control.
2.
The lights will flash 3 times.
3.
The rear defogger output will once again activate when the
vehicle is remote engine started.
N
NO
OT
TE
E:: If the remote engine start is on the lights will turn off
then flash 3-times before returning to their normal output and
the defogger output will activate as programmed.
The Valet Take-Over feature allows the vehicle to remain running
after the key has been removed from the ignition. This feature is
useful for occasions when you wish to exit and lock the vehicle for
short periods of time, but would like to leave the motor running
and the climate controls on.
To perform Valet Take-Over:
1. Before turning off the engine, press and release
twice
within 2 seconds (or press and release the optional Momen-
tary switch).
2. Turn the ignition key to the OFF position.
(The engine will stay running.)
3. The engine will run until the pre-programmed time elapses or
a shut-down input is received. (See the previous remote
engine start section for a complete list of shut-down inputs.)
NOTE: This feature will not work if the brake pedal is being pressed.
Valet Take-Over