Samsung WA80V3 - Manual (Page 10)

installation ^ maintonance
HOW TO CONNECT THE DRAIN HOSE
IN CASE OF PUMP-DRAINED WASHER
J
Be sure to join tightly the
drain hose into the drainoutlet
on the back of the machine. Be sure to join tightly the drain
hose into the drain-outlet on
the side of the machine.
,cap-hose -+
Take out the cap-hose and
connect the outlet-hose. Install the drain hose In the
position of about 90~100cm
above the ground.
CONNECTING THE DRAIN HOSE
After pressing thejoint ring(a), insert the drain hose(b)
to drain direction.
HOW TO PUT THE DETERGENT IN
1. Open the detergent box by pulling inthe direction of the arrow as shown in the figure
and then put the powder detergent in the detergent box.
2. Put in one-time amount of detergent evenly so the detergent may not brim over the box.
HOW TO ADD THE FABRIC SOFTENER
Slide and open the cover in the direction of the arrow, insert the rinse detergent, and slide and close it in the reverse direction.
• When a proper amount (one time does) of fabric softener is stored in the softener inlet,
if is automatically put in at the last rinsing cycle.
• Do not use detergent, bleach or starch info the Softener Inlet.
• Using too much softener may produce unsatisfactory results.
• Do not open the lid during the Spin Dry cycle. If added too early, its effectiveness will decrease.
• Do not leave the softener info the Softener Dispenser for a long time. Because softner became stiff.
WATER SUPPLY CONNECTOR FILTER
1. Pulloufthefilterandwashwell. 2. Pull in the filter and connect the
hose to the inlet water valve tightly.
3. Check if there is a leakage. Note
to tighten up the connector.
CLEANING THE FILTER
1. Push the upper part of the Magic
filter and pull in.
3. Clean the Magic filter.
2. Openfhecoverasshowninfhe
figure.
Close the cover and insert the lower
part of the filter in the basket first and
then push the filferwith “click” sound.
HOW TO CLEAN THE PUMP FILTER
1. Place a rag under the washer filter not to wet the floor.
2. Rotate the filter oounferolookwise and pull out the filter.
3. Remove dirts and rotate the filter olookwise until if looks in position.
10_lnstallation & maintenance
WA91U3-02594C_EN.indd 10 2008-04-11 ¿AAu11:42:52