Samsung WA80V3 - Manual (Page 9)

installation ^ maintonance
The User's Manual is for common use. Make use of fhe User's Manual depending upon your washing machine model.
ENVIRONMENT
Leave some space - Maintain at least 10cm between the washer and the wall.
Place the washer on a sturdy flat surface. - If the washer is placed on an uneven or weak surface, noise or
vibration occurs. (Allowable is 1°) Adjust the legs for even placement.
Never install the washer near water. - Do not plaoe the washer in steamy rooms or where the washer is direotly
exposed to rain. Moisture may destroy the eleotrioal insulation oausing an eleotrioal shook hazard.
Avoid direct sunlight or heaters. - As plastic an electrical components are affected by direct heat, never
place the washer near furnaces, boilers, etc. Do not place under direct sunlight.
LEVELLING
Water
If the washer is not leveled with the ground, it makes the machine tremble more or be out of order.
So, make sure that the washer is leveled properly.
SEE IF THE MACHINE IS PLACED LEVEL BY CHECKING THE POSITION OF THE
WASHING TUB.
• Open thelid of the machine, pour waterinto the tub up to the leveljust below the pulsator, and
adjust thelegs so that the pulsatoris positioned at the center of the water as shownin the figure.
• Place the machine more than 10cm away from the wall.
• Adjust the legs on feet for levelling.
CONNECTING THE WATER SUPPLY HOSE
LOOSEN LOOK
1. Remove the adaptor from the water
supply hose.
4. Connect the water supply hose to the
adaptor. Pull down the part (c) of the
water supply hose. When the part (c)
Is released, the hose Is automatically
connected to the adaptor making a
‘click’ sound.
2. First, using a “+” type screw driver, loosen
the four screws on the adaptor. Next, take
the adaptor and turn part(b) following the
arrow for gap about 5 mm between them.
5. Conneot the other end of the
water supply hose to the inlet
water valve at the baok of the
washer. Sorewthe hose olookwise
all the way in.
3. Connect adaptor to the water tap by
tightening the screws firmly. Then, turn
part(b) following the arrow and put (a)
and (b) together.
-W-
5-1. Connect the other end of the water
supply hose to the inlet water valve
at the top of the washer. Screw the
hose clockwise all the way in.
If the water tap is a screw type, assemble a water supply hose that fits to the tap as shown.
After completing connection, if water leaks from the hose, then repeat the same steps.
After completing connection, if water leaks from the hose, then repeat the same steps.
Use the most conventional type of faucet for water supply.
In case the faucet is square or too big, remove the spacing ring before inserting the faucet into the adaptor.
ASSEMBLING THE RAT PROTECTION PANFI OiTOifalW
Tilt the washer a little and lift up the panel until it
olioks, finally fix the panel with sorew to the base
as shown in the figure. 1. Insert the rat proteotion panel to the
assembling hole on baok side to the
end.
2. Ifyou have diffioulty inserting the
panel lift up the washer a little and
insert it.
Installation & maintenance _9
WA91U3-02594C_EN.indd 9 2008-04-11 ¿AAЬ 11:42:46