Cd player, Tape deck, Tuner – Sony LBT-G1300 User Manual

Page 24

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

CD Player

The CO tray does not close.

• The CD is not placed piopeily.

The CO will not play.

•The CD is dirty.
• The CD is inserted label side down.
• Moisture condensation has built up.

Remove the CD and leave the system
turned on for about an hour until the
moisture evaporates.

Play does not start from the first track.

• The player is in program or shuffle mode.

Press SHUFFLE or PRCX5RAM so that
"SHUFFLE" or "PRCX3RAM" disappears.

Tape Deck

The tape does not record.

• No tape in the cassette holder.
• The tab has been reihoved from the

cassette (see "To save a tape
permanently" on page 22).

• The tap« has reeled to the end. '

The tape does not record nor play or there

is a decrease in sound level.

• The heads are dirty. Clean them (see

"Cleaning the tape heads" on page 23).

• The record/playback heads are

magnetized. Demagnetize them (see
"Demagnetizing the tape heads" on page
23).

The tape does not erase completely.

• The record/playback heads are

magnetized. Demagnetize them (see
"Demagnetizing the tape heads" on page
23).

There is excessive wow or flutter, or the

sound drops out.

• The capstans or pinch rollers are dirty.

Clean them (see "Cleaning the tape
heads" on page 23).

Noise increases or the high frequencies are
erased.

• The record/playback heads are

magnetized. Demagnetize them (see

"Demagnetizing the tape heads" on page

23).

Troubleshooting (continued)

Tuner

Severe hum or noise ("TUNED" or
"STEREO" flashes in the display.

• Adjust the anteima.

■ • The signal strength is too weak. Connect

the external antenna.

If the system malfunctions due to
a cause other than the ones
mentioned above

This system coordinates its performance by
using built-in microcomputer chips.
Therefore there may be a case where the
system does not operate properly if the
condition of its power source etc. is unstable.
In such a case, turn the system's power off
and then turn it on again. If the system stiU
does not operate properly, consult yoiu:
nearest Sony dealer.

24

Advertising