Sony LBT-G1300 - Manual (Page 7)

4 Press PRESET + or - and select the
preset number you want.
Preset number
5 Press MEMORY.
The station is stored.
6
Repeat steps 1 to 5 to store other
stations.
To tune in a station with a weak
signai
Press ►►»O or KM-« repeatedly to tune
in the station.
To change the preset number
Start again from step 1.
To change the AM tuning interval
(except for North American,
Mexican, Australian and Middle
Eastern models)
The AM tuning interval is factory-preset to 9
kHz (10 kHz in some areas). To change the
AM tuning interval, turn off the power and
change the position of the AM TUNING
STEP switch on the rear panel to 10 kHz (or 9
'kHz). Then turn the power back on. To reset
the interval, repeat the same procedure.
Tip
The preset stations are retained for a week even if
you pull out the AC power cord or if a power failure
occurs.
Connecting optional
AV components and
outdoor antennas
Connecting a turntable
To enhance your system, you can coimect a
turntable. Refer to the instructions of each
component.
Make sure to match the colour of the plugs
and the connectors.
To the audio output of a turn table.
To listen to the sound of a
turntable
Press PHONO.
"Phono" appears in the display.
Tip
You can record the turntable sound.
continued