Precautions, Specifications, Additional information – Sony TC-WE305 User Manual
Page 8
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Additional Information
Precautions
On safety
• Do not disassemble the cabinet — this
may result in an electrical shock.
Refer servicing to qualified personnel
only.
• Should any solid object or liquid fall
into the cabinet, unplug the tape deck
and have it checked by qualified
personnel before operating it any
further.
On power sources
• Before operating the tape deck, check
that the operating voltage of the tape
deck is identical with your local
power supply. The operating voltage
is indicated on the nameplate at the
rear of the tape deck.
• ' The unit is not disconnected from the
AC power source (mains) as long as it
is connected to the wall outlet, even if
the unit itself has been turned off (not
applicable to European models).
• If you are not going to use the tape
deck for a long time, be sure to
disconnect the tape deck from the
wall outlet. To disconnect the AC
power cord, grasp the plug itself;
never pull the jord. .
• AC power cord must be changed only
at the qualified service shop.
On operation
• Because of a safety mechanism, the
function buttons will not operate if
the cassette holder is not completely
closed, if there is no cassette in the
cassette holder, or if a cassette has
been incorrectly inserted into the
cassette holder.
• Be sure to stop the tape before turning
off the tape deck. Otherwise, the tape
may be damaged.
On placement
• Place the tape deck in a location with
adequate ventilation to prevent heat
build-up in the tape deck.
• Do not place the tape deck:
— on a soft surface such as a rug that
might block the ventilation holes
on the bottom.
— in a location near heat sources.
— in a place subject to direct sunlight.
— in an inclined position.
— in a place subject to excessive dust
or mechanical shock.
On cleaning the tape deck
Clean the cabinet, panel and controls
with a soft cloth slightly moistened with
a mild detergent solution. Do not use
any type of abrasive pad, scouring
powder or solvent such as alcohol or
benzine.
For the customers in the United
States
For detailed safety precautions, see the
leaflet "IMPORTANT SAFEGUARDS".
If you have any questions or problems
concernipg your tape deck, please
consult your nearest Sony dealer.
Specifications
System
Recording system
4-track 2-channel stereo
Fast-winding time (approx.)
120 sec. (with Sony C-60 cassette)
Bias
AC bias
Signal-to-noise ratio (at peak level and
weighted with Dolby NR off)
Type I tape, Sony Type I (NORMAL):
55 dB
Type II tape, Sony Type II (HIGH):
57 dB
Type IV tape, Sony Type IV
(METAL): 58 dB
S/N ratio improvement (approximate values)
With Dolby NR on: 5 dB at
1 kHz, 10 dB at 5 kHz
Harmonic distortion
0.4% (with Type 1 tape, Sony Type I
(NORMAL):
160 nWb/m 315 Hz, 3rd H.D.)
1.8% (with Type IV tape, Sony Type
IV (METAL):
250 nWb/m 315 Hz, 3rd H.D.)
Frequency response (Dolby NR off)
Type I tape, Sony Type I (NORMAL):
30 -14,000 Hz (±3 dB, lEC)
20- 15,000 Hz (±6dB)
Type II tape, Sony Type II
(HIGH):
30 -15,000 Hz (±3 dB, lEC)
20 -16,000 Hz (±6 dB)
Type IV tape, Sony Type IV
(METAL):
30-15,000 Hz(±3dB, lEC)
20- 16,000 Hz (±6 dB)
30 -13,000 Hz (±3 dB,
-i
dB
recording)
Wow and flutter
±0.21 % W. Peak (lEC)
0.15 % W. RMS (NAB)
±0.3 % W. Peak (DIN)
Inputs
Line inputs (phono jacks)
Sensitivity : 0.16 V
Input impedance : 47 kilohms
Outputs
Line outputs (phono jacks)
Rated output level: 0.5 V at a load
impedance of 47 kilohms
Load impedance : Over 10
kilohms
General
Power requirements
120 V AC, 60 Hz
Power consumption
27 W
Dimensions (approx.)
430
X
120
X
305 mm (w/h/d)
(17
X
4’A
X
12'/« inches)
including projecting parts and
controls
Mass (approx.)
3.3 kg (7 lbs 4 oz)
Supplied accessories
Audio connecting cords (2 phono
plugs - 2 phono plugs) (2)
Design and specifications are subject to
change without notice.