Connecting a satellite receiver, Sat) and a vcr, Note – Sony KP-61V90 User Manual
Page 17
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Connecting a satellite receiver
(SAT) and a VCR
1
Connect the cable from the satellite
antenna to the satellite receiver,
2
Attach the coaxial cable from the
incoming cable connection or antenna to
VHF/UHF IN on the VCR.
3
Using a coaxial cable, connect VHF/UHF
OUT on the VCR to VHF/UHF on the
projection TV.
4
Using AUDIO and S VIDEO* cables,
connect AUDIO and S VIDEO OUT on the
satellite receiver to AUDIO and S VIDEO
IN on the VCR.
5
Using AUDIO and S VIDEO* cables,
connect AUDIO and S VIDEO OUT on the
VCR to AUDIO and S VIDEO IN on the
projection TV (White-AUDIO Left, Red-
AUDIO Right).
*If your VCRis not equipped with S VIDEO, use a
VIDEO cable (yellosv) instead of the S VIDEO
cable.
Note:
• To view input from the satellite receiver or
VCR, select the video input which your
satellite receiver or VCR is connected to
by pressing TV/VIDEO on the remote
control.
Disconnect aff power sources before making any connections.
{Rear of projKtisn T¥|
S ¥lBEO
¥C-1S¥/30¥ Cost supplied!
13