Sony DA V-HDX5OO - Manual (Page 85)

Comiccl the calibration mic to the A.CAL
MIC jack on the front panel, and set it up at
the car level using a tripod, etc. (not
supplied). The front of each speaker should
face (he calibralittn mic, and there should be
no ohslruction between the speakers and the
calibration mic. Be quiet during the
measurement.
AUDIO IN/A.CALMIC ®
5
Press I'/'i' to select [YES], then press
©.
Calibration starts.
• Avoid being in the incasuremenl area and
making noise during the measurement iahoiil
one minute), to avoid rneiisiirement failure.
[)iiring Ihe measurement, test signals are outpiil
from the speakers.
• The environment of the room in which the
system is installed may affect measurements.
• If an error message appears, follow the message,
then select |YES],
An error message appears when:
- the headphones are conneeted.
- the calibration mic is not connected.
- front speakers are not correctly connected,
- surround speakers are not correctly
connected,
- front and surround speakers are not correctly
connected.
- subwoofer is not connected.
Press to select [YES] or [NO],
then press 0.
■ The measurement is OK.
Discoiiiicct the calibration mic, then select
[YES]. The result is implemented.
Mrujsiji.anicnfdoirijtkjf:... -.:- :
FFiGNTL;. ' •' •" .• .• iiitt. 'd.B^/in. •. :6.UdB.
FRONTR: ::
. •.TOP :.4:b7rn: •
OENTEft-: • • • • •':' -Ifift' •4,B7m-: f
oUBv/OOFER:: .•. KiW. a.BYi'iv.;'. 4;0jB
AdRBOU.Mb k: : : -.toil:: iYtHnV:--¿.(XIB
AURROUIfJ.l-i-R r • 10.M:: i-db-ihi: '-.¿dVIEr
It OR. liiiplU'j v3llbi'iiiloii trijiri-<ivi ¿elect-
.-YEG";
[ YES
■ The measurement is not OK.
Follow the message, then select |YES] to
retry.
rclo.vmr'iirieii-tjailuirc." • .
;C..fiack ¿paakaj: c.c-riii&Gtibri.-'
Rdti-v-i
YES
.MG :■ :■:
► You can check the distance between the listening
position and each speaker. Sec page 92.
>
a
<
a)
3
o
(D
a
I
>
Q.
continued-
85^^®