Section 6, Programming instructions, 1 requirement – Sony CMD-CD18 User Manual
Page 17: Preparation for software update, 2 hardware set-up, Software set-up, Loading new software into the flash
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Section 6
PROGRAMMING INSTRUCTIONS
6.1 Requirement
• PC (486 type or higher) with Microsoft “Windows” Operating System
• One COM-port free for usage
The Data Transfer Jig (p/n 1-792-172-11)
PREPARATION FOR SOFTWARE UPDATE
DATA
TRANSFER JIG
6.2 Hardware set-up
• Copy all the files to the PC (define own directory).
• Connect the Data Transfer Jig to the PC COM-port (COM 1 or COM 2) and the CMD-CD18 external connector.
• Attach battery pack to CMD-CD18; the CMD-CD18 is powered up from the battery pack.
• The Initial settings of the flash.exe program may not correspond with the normally correct settings. It is highly
advisable to check the settings first (see 3.Software set-up).
3. Software set-up
•
Loading new software into the flash
•
Start the program flash.exe by double-clicking on its icon in the explorer.
Fiash.exe
•
Select “File’TSettings...” and check if the settings for the “Com Port”, the “Baud Rate” and the “Erase Mode”
are correct. Normally the “Load Options” do not have to be changed. The default values are ;
Com Port:
Baud Rate ;
Load Options :
Erase Mode :
COM 1
115200
Both
Program Area, Smart Erase
(! disable melody area for normal software update)
(! disable NVM data area for normal software update)
17