Hookups, Connecting the ac power cord, Transporting the player – Sony CDP-CE215 User Manual

Page 5: Getting started, Disc

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

Getting Started

Hookups

When connecting an audio cord, be sure to match the

color-coded cord to the appropriate jacks on the

components: Red (right) to Red and White (left) to

White. Be sure to make connections firmly to avoid

hum and noise.

CD player

Amplifier

■Q' You can adjust the output level to the amplifier (CDP-

CE315 and CDP-C260Z only) |j |

Press LINE OUT LEVEL +/- on the remote. You can

reduce the output level up to -20 dB.

When you reduce the output level, "ATT." appears in the

display.

When you turn off the player, the output level

automatically returns to the maximum level.

Note

If you press the LINE OUT LEVEL +/- buttons on the

remote while recording, the recording level will change

even when it is preset on the tape deck, etc.

• If you have a digital component such as a digital

amplifier, D/A converter, DAT or MD (European models

only)

Connect the component via the DIGIJAL OUT (OPTICAL)

connector using the optical cable (not supplied). Take off

the cap and plug in the optical cable.

Note that you cannot use fading in or out (page 15) and

Time Fade (page 15) functions when making this

connection.

Setting the voltage selector (voltage
selector equipped models only)

Check that the voltage selector on the rear panel of the

player is set to the local power line voltage. If not, set

the selector to the correct position using a screwdriver

before cormecting the AC power cord to a wall outlet.

220 - 240 V

110-120V

Connecting the AC power cord

Connect the AC power cord to a wall outlet.

Transporting the player

Before transporting the player, follow the procedure

below to return the internal mechanisms back to their

original position.

1

Remove all the discs from the disc tray.

2

Press a OPEN/CLOSE to close the disc tray.

"no

disc"

appears in the display.

3

Wait for 10 seconds, then press POWER to turn off

the player.

■d

POC-15

-cj b-

Optical cable (not supplied)

CD piayer Digitai component

Note

When you connect via the DIGITAL OUT (OPTICAL)

connector, noise may occur when you play CD software other

than music, such as a CD-ROM.

Z E N

Advertising
This manual is related to the following products: