On operating voltage, On safety, On placement – Sony MHC-F150 User Manual

Page 52: On operation, Notes oivcds, Cleaning the cabinet, To save a tape permanently, Precautions, Additional information

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

Additional Information

Precautions

On operating voltage

IVtore operating the system, check that the

operating voltage of your system is identical with
{he \ oltage of your local power supply.

On safety

• The unit is not disconnected from the AC power

source (mains) as long as it is connected to the
wall outlet, even if the unit itself has been turned
off-

• Unplug the system from the wall outlet (mains) if

it is not to be used for an extended period of time.
To disconnect the cord (mains lead), pull it out by
the plug. Never pull the cord itself.

• Should any solid object or liquid fall into the

compoiient, unplug the stereo system and have
the component checked by qualified personnel
before operating it any further.

• The AC power cord must be changed only at the

qualified service shop.

On placement

• Place the stereo system in a location with adequate

ventilation to prevent heat build-up in the stereo
system.

• IX> not place the unit in an inclined position.
• Do not place the unit in locations where it is;

— Extremely hot or cold
— Dusty or dirty

— Very humid
— Vibrating
— Subject to direct sunlight

On operation

• If the stereo system is brought directly from a cold

to ti warm location, or is placed in a very damp
room, moisture may condense on the lens inside
the CD player. Should this occur, the system will
riot operate properly. Remove the CD and leave
the system turned on for about an hour until the
moisture evaporates.

• When you move the system, take out any discs.

ll you have any questions or problems concerning

\ our stereo system, please consult vour nearest
Siin\’ dealer.

Notes oivCDs

• Before playing, clean the CD with a cleaning cloth.

Wipe the CD from the center out.

• Do not use solvents such as benzene, thinner,

commercially available cleaners or anti-static
spray intended for vinyl LPs.

• Do not expose the CD to direct sunlight or heat

sources such as hot air ducts, nor leave it in a car
parked in direct sunlight.

Cleaning the cabinet

Use a soft cloth slightly moistened with mild
detergent solution.

To save a tape permanently

To prevent a tape from being accidentally recorded
over, break off the cassette tab from side A or B as
illustrated.

If you later want to reuse the tape for recording,
cover the broken tab with adhesive tape. However,

be careful not to cover the detector slots which allow

the tape player to automatically detect the type of
tape.

o X

fl]

=fi

Detector slots

Advertising
This manual is related to the following products: