Sony CDP-CA8ES - Manual (Page 6)

Getting Started
If you have an analog power amplifier
Connect the amplifier via the VARIABLE LINE OUT jacks
using the supplied audio cord. You can adjust the output
level with the LINE OUT/PHONE LEVEL control on the
player or the LINE OUT LEVEL buttons on the remote.
CD player Amplifier
LINE O UT ' INPUT '
VARIABLE CD
O0^ — ©L
— © R
Connecting the AC power cord
Connect the AC power cord to a wall outlet.
Where do I go next?
Now you're ready to use your player.
If you aren't familiar with how to play CDs, go to the section
"Playing a CD" on page 4.
Then, go to the following sections for other operations.
If you have a digital component such as a digital
amplifier, D/A converter, DAT or MD
Connect the component via the DIGITAL OUT (OPTICAL)
connector using the optical cable (not supplied). Take off
the cap and plug in the optical cable.
Note that you cannot use fading in or out (page 13) and
Level File (CDP-CA9ES only, page 17) functions when
making this connection.
<Q3-
POC-15
- c Q t -
CD player
Optical cable (not supplied)
Digital component
Note
When you connect via the DIGITAL OUT (OPTICAL)
connector, noise may occur when you play CD software other
than music, such as a CD-ROM.
Transporting the player
Before transporting the player, follow the procedure
below to return the internal mechanisms back to their
original position.
1 Remove all the discs from the disc tray.
2 Press = OPEN/CLOSE to close the disc tray.
"-NO DISC-" appears in the display.
3 Wait for 10 seconds, then press POWER to turn off
the player.
If you have a Sony CD player, receiver or amplifier with
the CONTROL S OUT connector
Connect the component via the CONTROL S IN connector
using the CONTROL S cable (not supplied). You can
remotely control this player through the other component.
CD player Other component
CONTROL S CONTROL S
IN OUT
- l-'-l
V J
1 ' i
L /