Battery care, How to use the switch on the battery pack, The life of the battery pack – Sony CCD-TR700 User Manual

Page 47: Charging temperature, Sony batteries are recommended, Note on charging a brand-new battery, Before recharging a used battery pack, After long storage

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

Note on the Rechargeable Battery Pack

The Battery Heats Up

During charging or recording, the battery pack heats up. This is caused by energy that has been

generated and a chemical change that has occurred inside the battery pack. This is not cause for concern.

Battery Care

• Remove the battery pack from the camcorder after using the battery ptack, and keep it in a cool place.

When the battery pack is attached to the camcorder, a small amount of current flows to the camcorder
even if the TOWER switch is set to OFF, which shortens battery life.

• The battery pack is always discharging even when it is not in use after charging. Therefore, you should

charge the battery right before using the camcorder.

How to Use the Switch on the Battery Pack

This switch is provided so that you can mark the charged battery. Set the switch to the "no nrark"

position when charging is completed. Set the switch to the "red mark" position when the battery is used
up (or in whichever direction you want to remind yourselO.

[c]

on page

46.

The Life of the Battery Pack

The battery pack can be fully charged and discharged about 500 times under normal temperatures. If the

battery indicator flashes rapidly just after turning on the camcorder with a fully charged battery pack,

the battery pack should be replaced with a new fully charged one.

Charging Temperature

You should charge batteries at temperatures from 50®F to Sô^F (from 10®C to 30®C). Lower temperatures

require a longer charging time.

Sony Batteries are Recommended

Use of non-Sony batteries may damage your Handycam camcorder.

Note on Charging

A Brand-new Battery

A brand-new battery pack is not charged. Before using the battery pack, charge it completely.

Before Recharging a Used Battery Pack

• Make sure to use up the battery before recharging.
• If recording is completed before the Cg indicator appears in the viewfinder, you should remove the

tape, slide the TOWER switch to CAMERA, turn up the STANDBY switch, and leave the camcorder

until the battery indicator flashes rapidly.

• When you use the AC-SIO power adaptor or the DC-SIO car battery charger, you can use the

discharging function.

• Charging the usable battery causes a lowering of battery capacity. Battery capacity can be

recovered if you fully discharge and charge the battery again.

After Long Storage

Recharge the battery pack after a long period of storage. If the battery pack is charged fully but not used
for a long time (about lyear), it becomes discharged. Charge it again, but in this case the battery life will
be shorter than normal. After several charging and discharging cycles, the battery life will recover its
original capacity.

47

Advertising