Hanging vac on storage rack – Craftsman 113.179255 User Manual
Page 9
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Hanging Vac on Storage Rack
1. Set the vac on the floor near the stor
age rack. Measure the distance from
center of storage rack to the closest
electrical outlet and add 1B inches.
2. Uncoil that amount of power cord from
the cord wrap. Drape the loose cord
over the top of the vacuum and down
the front.
3. Grasp the handle with one hand and
the bottom of the vac canister at the
front foot with the other hand. Always
lift the vac with both hands. Lift the vac
up to the storage rack.
4. Align the upper hook on the vac with
the rectangular opening in the storage
rack. Push the vac against the storage
rack.
Storage
Rack
Retangular
Opening in
Storage
Rack
Upper
Vac
Hook
Push Vac
Against
Storage
Rack
Release Tab
Depressed
Vac
Canister
5. Lower the vac until the upper vac hook
and lower hook are engaged and the
bottom of the vac canister rests on the
rack. The release tab will pop out over
top of vac.
6. Snap the power cord into the cord
retainers in the front surface of the rack
and loop around the keeper behind the
wand storage area. The cord may exit
on either the left or right side. Plug the
power cord into the electrical outlet. Do
not fasten power cord to wall in any
way.