Tools required for assembly, Remove pressure washer from carton, Preparing the pressure washer for first use – Craftsman 919.769020 User Manual
Page 6
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Tools Required for Assembly
Adjustable wrench
1/2” Socket
Remove Pressure Washer from Carton
• Open carton from the top. Locate and remove from
carton, the parts box, which includes gun, handle,
wand,oil, knobs and bolts. Next remove the parts
bag and the handle.
• Cut carton along dotted lines.
• Remove ail carton Inserts.
• Roll unit through opening in carton.
Note: The pressure and chemical hose are located at
the bottom of the box.
Preparing the Pressure Washer for First Use
Note: included with your pressure washer is a video
tape on how to prepare your unit for operation, it is
recommended you view this tape before performing
the next steps.
1. insert handle onto frame.
• insert knobs into the threaded slot in front of the
frame handle and tighten by turning in a clockwise
direction.
'v
^ • Slide bolts into the slot in the side of the frame
handle and tighten the nut by turning in a clockwise
direction.
2.
Remove wood plank from the frame of the unit.
An adjustable wrench is required. Discard bolt
and board.
3. Mount the rubber isolator to the frame.
• To mount isolator place threaded end of bolt
through the washer.
• Next with washer on bolt place threaded end
of bolt through larger hole in bottom of the
rubber isolator. Place threaded portion of
isolator through the front hole location where
the wood plank was mounted on the pressure
washer.
• Next place lockwasher over threaded portion
of bolt that has been placed through the
mounting hole in the pressure washer and use
nut to tighten isolator to the frame.
• Tighten nut with an adjustable wrench.
NUT
PRESSURE
WASHER
FRAME
¿
LOCKWASHER
/ /
WASHER—<S>
BOLT
4.
Connect wand with nozzle assembly to gun. To
tighten, turn knob in clockwise direction. Hand
tighten.