Craftsman 919.769020 User Manual
Page 7
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
5\
Cut tie wrap off of high pressure hose. Unwind
high pressure hose to attach the threaded end to
the gun. Tighten with adjustable wrench.
8
.
6. Connect chemical hose to the chemical injector
hose barb on pump.
7.
Connect high pressure hose to the quick connect
outlet on pressure washer.
NOTE: Always keep hose away from engine
muffler.
Your units pump is shipped with a
temporary plug that must be replaced with a
breather cap. This plug is located over the
pump’s oil port. Unscrew and remove this plug.
Remove the breather cap from the bag attached
to the plug and install it in the pump’s oil port.
BREATHER
CAP
A CAUTION: Failure to replace the plug will result
in serious pump damage.
9. Place assembled gun and wand on pressure
handle bracket as shown.
Checklist
Before going any further please review the following:
• Be sure you have completed assembly instruction.
• Double check all fittings to be sure they are tight.
IMPORTANT: Before any attempt to start your pres
sure washer be sure to check engine oil {See Operation
under Engine Oil, page 9.)