HP Netserver L Server series - Manual (Page 19)

Chapter 1 Installation Overview
2. If a side cover was removed, insert the channel on its lower edge onto the
lip at the bottom of the chassis. Press the top of the side cover against the
chassis to snap it into place.
3. To replace the top cover, do the following:
a. Align both of its rear corners against the similar metal on the rear of the
HP NetServer.
b. Lower the ^ont of the top cover, and pull it forward slightly to catch on
the rear of the HP NetServer and to clear the front edge of the HP
NetServer.
c. With the top cover in place, tighten both thumbscrews.
4. Align the ^ont bezel against the ^ont of the HP NetServer, and press it
^rmly into place.
5. Lockthefrontbezelwiththekey.
6. Connect the power cord and all other cables.
Configure the HP NetServer
Run SCSISelect Utility
If you need to verify or modify SCSI host adapter settings, or if you need to low-
level format SCSI disks or verify SCSI disk media, run the SCSISelect utility, as
follows:
1. Turn on or reboot your system.
During system start-up or reset, when the message
Press <Ctrl> <A> for SCSISelect(TM) Utility
appears, press the CTRL and A keys at the same time.
2. From the Options menu, select one of the following:
0 Configure/View Host Adapter Settings: Select this option to
con^gure or view SCSI bus interface de^nitions, boot device options,
SCSI con^gurations, and advanced con^guration options.
0 SCSI Disk Utilities: Select this option to format disks or verify disk
media.
1 3