HP Netserver L Server series - Manual (Page 8)

Chapter 1 Installation Overview
1. If you are not already running HP Navigator on the HP NetServer LC II,
boot the HP NetServer LC II from the HP Navigator CD-ROM:
a. Press the power-on button. Press the CD-ROM drive eject button. Place
the HP Navigator CD-ROM in the drive, and press the eject button
again to close the drive. Turn the power off, wait 10 seconds, and turn
the power on again. If the system fails to start, follow the diagnostic
instructions on the screen.
b. Go to the HP Navigator Main Menu. If the language needs to be
changed, select User Preferences and the language you want.
2. From the HP Navigator Main Menu, select NetServer Utilities.
3. From the NetServer Utilities menu, select Diagnostic Assistant.
4. To understand Diagnostic Assistant and the hardware it can test, view the
Readme text, as follows:
a. From the Diagnostic Assistant Main Menu, select either Quick Tests or
Continuous Tests.
b. From the next menu displayed, select On-Line Manual.
c. When you have finished viewing the Readme text, press ESC twice to
return to the Diagnostic Assistant Main Menu.
Remove the Covers
If you are not installing additional hardware (or only hot swap disk drive
modules), you do not need to remove any covers. Go to the heading, "Configure
the HP NetServer."
If you are installing any hardware options (other than hot swap disk drive
modules), you must remove the iront bezel and top cover.
• If you are installing accessory boards or additional mass storage devices
(other than hot swap disk drive modules), you must also remove the side
cover farthest irom the system board. Reler to Figure 1-1.
• If you are only installing additional memory, do not remove the side cover.
To install options, you will need a flat 1/4-inch screwdriver and T15 TORY®
driver.