HP Netserver L Server series - Manual (Page 7)

1 Installation Overview
This chapter contains simplified setup information about your HP NetServer
LC II. For complete setup instructions, consult the
HP NetServer LCII
Installation Road Map.
Verify Contents
Unpack and verify the contents of the shipping box against the Contents Checklist
included with your HP NetServer. If anything is missing or damaged, contact your
reseller.
• If you do not plan to install the HP NetServer in a rack assembly, mount it
on the anti-tip pedestal now, as instructed in the HP NetServer LC II
Installation Road Map.
• If you do plan to install the HP NetServer in a rack assembly, do not mount
it on the anti-tip pedestal. Install it in the rack assembly after all options are
installed and the system is configured.
To remove the pedestal at a later time, refer to " Pedestal Removal" in Chapter 5,
"Installation in Rack (Optional)."
View the Readme File
1. Press the power-on button. Press the CD-ROM drive eject button. Place the
HP NetServer Navigator CD-ROM in the drive, and press the eject button
again to close the drive. Turn the power off, wait 10 seconds, and turn the
power on again. If the system fails to boot, follow the diagnostic
instructions on the screen.
2. Go to the HP Navigator Main Menu. If the language needs to be changed,
select User Preferences and the language you want. You can also change
the language of the BIOS when prompted.
3. Select Readme File. The Readme ^le contains the latest information to
help you install your HP NetServer. Read it care^ly before beginning your
installation.
Test the System Hardware (Optional)
If you want to veri^ the system hardware as shipped, you can now run HP
Diagnostic Assistant from the HP Navigator CD-ROM, as follows: