Craftsman 580.752000 - Manual (Page 9)

How to stop Your Pressure Washer
1. fi/love throttle lever to “Stop" position.
2. Squeeze trigger on spray gun to reiieve
pressure in hose.
NOTE: A small amount of water will squirt out when
you release the pressure.
How To Use the Adjustable Nozzle
You now should know how to START your pressure
washer and how to STOP it. The information in this
section will tell you how to adjust the spray pattern
and apply detergent or other cleaning chemicals.
CAUTION
A pressure washer produces a high pressure spray
which increases risk of injury and damage to unit.
NEVER:adjust sprayipattern wtrenispiraying.: 11111111
NEVER put hands in front of nozzle to adju^ spray pattern.
On the end of your spray gun is a nozzle handle that
can adjust the spray pressure and the spray pattern.
1. Point nozzle toward ground, disengage safety
latch, and cress trigger to test pattern.
' ^ .
2. Sliding nozzle forward and back adjusts spray
pressure.
high pressure rhode.
3. Rotating nozzle adjusts spray pattern from a
narrow pattern to a fan pattern.
Twist nozzle counter—
clockwise forfart: pattern,
Twist nozzle do
narrow: spray
iCkwise for
pattern.
4. For most effective cleaning, keep spray nozzle
between 8 to 24 inches away from cleaning
surface.
5. If you get spray nozzle too close, especially using
high pressure mode, you may damage the surface
being cleaned.
6. DO NOT get closer than 8 inches when cleaning
tires.
Using the Turbo Nozzle
The turbo nozzle rotates the high pressure stream in a
rapid circular pattern. The high pressure spray is most
effective when the tip of the nozzle extension is held
between B to 24 inches from the surface being cleaned.
CAUTION
The turbo nozzle produces an extremely high
pressure spray which is capable of removing paint
and cutting holes through surfaces if held too close.
Always: dske sure :the:su:rfaoe: you: will :dean:wili: not be
damaged by the high presure spray by testing in a
hidden :a:rea. : : : : : : : : : : : : : : : : : : : : : : : : : : : : : : : : : : : : : : : : : : : : : : : : : : : : : : : : : : :
To attach the turtxj nozzle to the gun;
1. Engage safely latch to spray gun trigger.
2. Remove the nozzle extension from the spray gun,
if attached.
3. Attach the turbo nozzle extension to spray gun.
Tighten by hand.
4. Disengage safety latch to spray gun trigger.
5. Always start the turbo nozzle at a distance,
gradually getting closer to the surface until you get
the cleaning force you want.
NOTE: Detergent cannot be applied with turbo nozzle.