Craftsman 247.270250 - Manual (Page 17)

2. Set the parking brake and push the vehicle. If the
rear wheels roll, adjust the brake following
instructions on page 20.
Tires
àk
WARNING: Never exceed meiximum limit of
air pressure shown on sidewall of the tire.
The recommended operating tire pressure is 20-22 psi
for both sets of tires. Refer to the tire sidewaii for exact
tire manufacturer’s recommendation. Do not
overinflate. Uneven tire pressure could cause the
cutting deck to mow unevenly.
Battery
The battery is located under the cup holder to the right
of the seat. The positive battery terminal is marked Pos.
(+). The negative battery terminal is marked Neg. (-).
A
WARNING: Battery posts, terminals and
related accessories contain lead and lead
compounds. Wash hands after handling.
• Always keep battery cables and terminals clean
and free of corrosive build-up.
• After cleaning, apply a light coat of petroleum jelly
or grease to both terminals.
• Always keep the rubber boot positioned over the
positive terminal to prevent shorting.
• If removing the battery for any reason, disconnect
the NEGATIVE (black) wire from its terminal first,
followed by the POSITIVE (red) wire. When re­
installing battery, always connect the POSITIVE
(red) wire to its terminal first, followed by the
NEGATIVE (black) wire.
iMPOFtTANT: Be certain that wires are connected to the
correct terminals; reversing them could change polarity
and cause damage to the engine’s alternating system.
• Check fluid level inside each cell of the battery
every two weeks and before and after charging.
Always maintain level just below the split rings.
• Add only distilled water. Never add additional add
or any other chemicals to the battery after initial
activation.
NOTE: If you have operated the tractor for a long
period, check the fluid level of the battery as it can
overheat and lose fluid.
Connecting Battery Cables
To reconnect battery cables, if the battery was removed
for some reason, follow instructions below.
1 .
2.
Remove three screws holding the cup and battery
holder to the frame of the unit.
Remove red and black insulation caps from battery
terminals.
3.
4.
5.
Remove battery terminal screws with a Phillips
screw driver or a 10 mm. socket wrench.
Attach the red battery cable to the positive terminal
(marked +), and the black battery cable to the
negative terminal (marked -) on the battery. See
Rgure 16.
Align the cables with tiie slots in the battery cover
and tighten the screws on the battery terminals.
See Figure 16.
WARNING: Press the battery cables against
side of battery so tiiat these do not make
contact with flange of rider frame when it is
opened or closed.
A
6. Re-install the battery cover and cup holder.
Cleaning the Equipment
1. Promptly wipe off any fuel or oil spilled on the
machine with clean cloth.
2. Clean the underside of the blade housing after
each mowing. Do not let clippings or debris
accumulate around the blade.
3. Using a brush or cloth, remove grass, chaff or
debris from the finger guard on the engine daily to
prevent overheating of the engine. Do not dean
with a forceful spray of water since water
contaminates the fuel system.
4. Keep the governor linkage, springs and controls
free of debris.
17