Storage, After each use, Winter storage – Craftsman 580.768040 User Manual

Page 14: Long term storage, Protect fuel system, Change oil, Oil cylinder bore, Other

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

STORAGE

AFTER EACH USE

Water should not remain in the unit for long periods of

time. Sediments of minerais can deposit on pump
parts and “freeze” pump action. Foiiow these
procedures after every use:

Flush the chemical system by selecting the System

Rinse tank and run the cleaning system with nozzle
in low pressure mode. Flush for one minute or until

the chemical is cleared from the system.

Shut off the engine and let it cool, then remove all
hoses.

A

CAUTION! Be sure the engine control switch is
in the “Off” position before you continue.

Empty the pump of all pumped liquids by pulling
recoil handle about

6 times with the engine controi

switch in the “Off” position. This should remove

most of the liquid in the pump.

Rotate the Diai-A-Cleaner™ selector knob to the

OFF position.

Coii the high pressure hose and inspect it for
damage. Cuts in the hose or fra^ng couid result in
teaks and ioss of pressure. Should any damage be
found, replace the hose. DO NOT attempt to repair
a damaged hose. Repiace the hose with the
genuine Craftsman part.

Drain water from hose and properly hang it on the

wire support provided on the guide handle.

Store system in a clean, dry area.

DANGER! Never store the engine with fuel In
the gas tank indoors or in enciosed, poorly

ventilated areas where fumes may reach an

open flame, a spark, or pilot light.

WINTER STORAGE

A

CAUTION! You must protect your unit from

freezing temperatures. Failure to do so will

permanently damage your pump and render

your unit inoperable.

To protect the unit from freezing temperatures:

* Empty all chemical reservoirs as follows:

a.

Disconnect hose connected to chemical inject

fitting on the pump. Place end of hose into

suitable container.

b.

Move the selector knob to Tank A and open

that tank’s cover. Gravrity should shortly empty
the tank contents into the container.

c.

When the tank is empty, repeat step (b) for
tanks B and C.

d.

Reconnect the hose to the chemical inject

fitting on the pump. Add 0.5 liter of clean fresh
water to each tank and close tank’s cover.

Flush the chemical system by selecting a tank and

run the cleaning system with nozzle in low pressure
mode. Flush until each tank is empty, then switch

the selector knob to the next tank. The last tank to

be emptied must be the System Rinse tank.

Connect a 3-fool section of garden hose to the inlet
adapter. Pour RV-Antifreeze (antifreeze without
alcohol) into the hose. Pull the recoil handle twice.

LONG TERM STORAGE

If you do not plan to use the cleaning system for more

than 30 days, you must prepare the engine for long

term storage. '

It is important to prevent gum deposits from forming in

essential fuel system parts such as the carburetor, fuel

filter, fuel hose or tank during storage. Also,

experience indicates that alcohol-blended fuels (called
gasohol, ethanol or methanol) can attract moisture

which leads to separation and formation of acids
during storage. Acidic gas can damage the fuel system
of an engine while in storage.

Protect Fuel System

A

DANGER! Drain fuel into approved container

outdoors, away from open flame. Be sure
engine is cool. Do not smoke.

Remove all gasoline from the fuel tank to prevent
gum deposits from forming on these parts and

causing possible malfunction of engine.

Run engine until engine stops from lack of fuel.
Make sure you have water supply to pump inlet

connected and turned ON.

Change Oil

While engine is stiH warm, drain oil from crankcase.

Refill with recommended grade. (See Changing Oil)

Oil Cylinder Bore

• Remove spark plug Squirt about 1 ounce (30 ml) of

engine oil into the cylinder. Cover spark plug hole

with rag. Crank engine slowty to distribute oil.

A

CAUTION! Avoid spray from spark plug hole

when cranking engine.

• Install spark plug. Do not connect spark plug wire.

OTHER

• Do not store gasoline from one season to another.

• if possible, store your unit indoors and cover it to

give protection from dust and dirt. BE SURE TO
EMPTY THE FUEL TANK.

IMPORTANT: NEVER cover your cleaning system

while engine and exhaust area are warm.

14

Advertising