Craftsman 580.768040 - Manual (Page 9)

Engage the safety iatch on the spray gun.
Attach adjustable nozzle extension onto spray gun.
Move choke lever to “CHOKE” position.
Note: If restarting a warm engine after a short
shutdown, move choke lever to “RUN.”
• Move engine control to “ON.”
Turn fuel shut-off valve to “ON” position.
• Grasp starter handle and pull slowly until you feel
some resistance. Then pull cord r^idly to
overcome compression, prevent kicldiack and start
the engine. Let rope return to starter slowly.
Note: If after 3 pulls the engine fails to start,
disengage the spray gun safety latch, squeeze the
trigger to relive water pressure, re-engage the spray
gun safety latch, move the choke control to the “Run”
position and pull the recoil starter handle rapidly (three
pulls maximum).
Note: The Pressure Command™ may be placed in
any position during starting or operation.
• When the engine starts, gradually move the choke
control from one position to the next until it is in the
“Run"’position.
• Disengage the spray gun safety iatch.
HOWTO STOP YOUR CLEANING
SYSTEM
• Move the engine control switch to the “OFF”
position.
• Turn fuel shut-off valve to “OFF” position.
• Simply shutting off the engine will not release
pressure in the system. Squeeze trigger on the
spray gun to relieve pressure in the hose.
Note: A small amount of water will squirt out when
you release the pressure.
• Rotate the Dial-A-Cleaner™ selector knob to the
"OFF” position to prevent chemical leakage.
SIPHONING
DO NOT siphon standing water for your water supply.
Contaminated, brackish or dirty water can damage the
pump. Connect only to household water supply.
TIPS
Never use the garden hose inlet to siphon
detergent or wax.
if you hold the spray nozzle too far away from the
object being cleaned, washing will not be as
effective.
Always store the cleaning system with the Dial-A-
Cleaner"^“ selector knob to the “OFF’ position.