Assembly, Carton contents, To remove cleaning system from carton – Craftsman 580.768040 User Manual
Page 4: Howto set up your cleaning system
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
ASSEMBLY
CARTON CONTENTS
The following parts are shipped loose with your
cleaning system:
•
Main Unit — Cleaning system with wheels,
chemical tanks, guide handle.
•
High Pressure Hose (already connected to pump)
•
Parts Box (which includes items listed beiow)
• Spray Gun
• Wand Extension with Hi/Lo Adjustable Nozzle
•
Engine Oil
• Three-pack of chemical concentrates
• Manual Bag (which includes the items listed
below)
•
Owner’s Manual
•
Nozzle Cleaner Kit
•
“
0--RingKit
• Tank Labels
Become familiar with each piece before assembling
the cleaning system. Ched< ail contents against the
illustration on Page 5. If any parts are missing or
damaged, call the Procure Washer HalpUne-at
1-800-222-3136.
'
TO REMOVE CLEANING SYSTEM
FROM CARTON
•
Remove loose parts and parts box included with
your cleaning system.
•
Slice two comers at guide handle end of carton
from top to bottom so the panel can be folded
down flat.
•
Raise guide handle, secure in place.
Lift the handle to
upright position and
slide the locking
caps into place
•
Roll the cleaning system out the open end of the
carton.'
•
Check carton for additional loose parts.
HOWTO SET UP YOUR CLEANING
SYSTEM
For the most part, your Craftsman High Pressure
Cleaning System has been assembled at the factory.
You must, however, assemble the spray gun and attach
it to th^ high pressure hose.
•
Cut the tie wraps on the high pressure hose and
connect high pressure hose to gun. Tighten by hand.
Attach nozzle extension to spray gun.