Craftsman 536.881800 - Manual (Page 29)

SERVICE AND ADJUSTMENT
HOW TO ADJUST OR REPLACE
THE FRICTION WHEEL
How To Check The Friction Wheei
If the snow thrower will not move for­
ward, check the traction drive belt, the
traction drive cable or the friction wheel.
If the friction wheei is worn or damaged,
it must be replaced. See “How To Re­
place the Friction Wheel” in this section.
If the friction wheel is not worn or dam­
aged, check as follows.
1. Run the engine until the fuel tank is
empty and the engine stops.
2. Stand the snow thrower up on the
front end of the auger housing
(see Figure 37).
3. Disconnect the spark plug wire.
4. Loosen the
bolts
on each side of
the
bottom panel
(see Figure 37).
5.
Remove the
bottom panel.
6. Position the
shift speed lever
in
the lowest forward speed.
7. Note the position of the friction
wheel (see Figure 38). The correct
distance
“A”
from the right side of
the
friction wheel
to the outside of
the motorbox is as follows:
Tire Size Distance “A”
12 and 13 inch 4-1/8”
16 inch 4-5/16”
If the friction wheel is not in the
correct position, adjust according to
the following instructions.
How To Adjust The Friction Wheel
1. Position the shift speed lever in
the lowest forward speed.
2. Loosen the bolts on the speed
control rod (see Figure 39).
3. Move the friction wheel to the cor­
rect position (see Figure 38),
4. Tighten the
bolts
on the
speed
control rod (see Figure 39).
F-0410108L
5. Install the bottom panel (see
Figure 37).
6. Tighten the
bolts
on each side of
the
bottom panel.
Bolt Bottom Panel
Figure 37
Figure 38
Speed Control Rod
Figure 39
29