Service and adjustment – Craftsman 536.881800 User Manual
Page 31
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
SERVICE AND ADJUSTMENT
11. Remove the three
fasteners
that
hold the
friction wheel
to the
hub
(see Figure 43).
12. Remove the
friction wheel
from the
hub.
Slip the
friction wheel
oft the
hex shaft.
13. Assemble the new
friction wheel
onto
hub
with the fasteners re
moved earlier.
14. Install the
hex shaft
and
bearings
with the four bolts removed earlier
(see Figure 44).
Make sure the washers are prop
erly installed in the original posi
tion. Also, make sure the two
washers are properly aligned
with the actuator arms.
15. Make sure the
hex shaft
turns free
ly-
16. Install the left wheel,
axle,
and
drive sprocket
with the fasteners
removed earlier. Install the
chain
onto the
drive sprocket
(see
Figure 41).
17. Check the adjustment of the friction
wheel. See “How To Adjust The
Friction Wheel” in this section.
18. Make sure the friction wheel and the
disc drive plate are free from grease
or oil.
19. Install the
bottom panel
(see
Figure 40).
20. Tighten the
bolts
on each side of
the
bottom panel.
21. Install the
right wheel
to the
axle
with the fasteners removed earlier.
22. Connect the spark plug wire.
F-0410108L
Washer
Washer
Figure 44