Craftsman 536.881130 User Manual
Page 10
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
ASSEM BLY
3. Position speed selector lever as
sembly as shown in Figure 11.
4. Reinstall bolt, spring, washer and
locknut See Figure 12,
5. Tighten locknut until 1/8 to 3/16 inch
of the bolt threads protrude pas the
locknut.
6. Thread the 3/8-16" hex jam nut
onto the lever until the nut reaches
the end of the thread. See
Figure 12.
7. Thread the plastic knob as far as
possible and ensure that the knob
points forward.
8. Tighten the 3/8-16" hex jam nut
against the knob securely.
9. Move shifter through all speeds to
ensure proper tension of the spring.
If shifter lever sticks in any of the
notches, loosen locknut 1/2 turn at a
time until shifter lever moves more
freely.
10. If adjustment of speed of snow
blower is needed, refer to "Friction
Wheel Adjustment” in the ADJUST-
MENT/REPAIR section.
Shift Bracket
Control
Panel
Figure 11
F-001060J
10