Craftsman 536.881130 User Manual

Page 20

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

M AINTENANCE

drive plate or friction wheel come in
contact with grease or oil, damage to
the friction wheel will result.

Should grease or oil come in contact

with the disc drive plate or friction

wheel, be sure to clean the plate and
wheel thoroughly,

NOTE: For storage, the hex shaft and

sprockets should be wiped with 5W30

motor oil to prevent rusting.
2. Auger Gear Box - The auger gear

box is lubricated at the factory and
should not require additional lubrica­
tion. If for some reason the lubri­
cant should leak out, have auger

gear case checked by a competent
repairman.

ENGINE

LUBRICATION

Check the crankcase oil level before
starting the engine and after each five

(5) hours of continuous use. See
Figure 21. Add S.A.E. 5W30 motor oil
as needed. Tighten fill cap/dipstick se­
curely each time you check the oil lev­
el.

Oil Fill Cap/Dipstick

Figure 21

Change the oil every twenty-five (25)
hours or at least once a year if the
snow thrower is not used for twenty-
five (25) hours.

TO CHANGE ENGINE OIL

1. Position the snow thrower so that

the oil drain plug is at the lowest
point on the engine.

2. Remove the oil drain plug and the

oil fill cap/dipstick. Drain the oil
into a suitable container.
NOTE: The oil will drain more freely

when the engine is warm.

3. After draining all the oil, reinstall the

oil drain plug securely.

4. Fill the engine crankcase with

S.A.E. 5W30 motor oil, pouring
slowly. DO NOT OVERFILL,

SPARK PLUG

Check the spark plug every twenty-
five (25) hours. Replace the spark plug

if the electrodes are pitted or burned or
if the porcelain is cracked.

1. Make sure the spark plug is clean.

Clean the spark plug by carefully
scraping the electrodes (do not

sand blast or use a wire brush).

2. Check the spark plug gap with a

feeler gauge and reset gap to 0.30”
if necessary. See Figure 22.

3. Before installing the spark plug,

coat the threads lightly with oil for

easy removal. Tighten the spark
plug to a torque of 15 foot-pounds.

Feeler Gauge

0.030'

Figure 22

F-001060J

20

Advertising