Craftsman 536.881130 - Manual (Page 29)

STORAGE
A WARNING; Never store your
snow thrower indoors or in
an enclosed, poorly venti­
lated area. If gasoline remains in the
tank, fumes may reach an open
flame, spark or pilot light from a fur­
nace, water heater, clothes dryer,
cigarette, etc.
NOTE:
To prevent engine damage (if
snow thrower is not used for more thi
30 days) follow the steps below. an
SNOW THROWER
1. Thoroughly clean the snow thrower.
2 . Lubricate all lubrication points. See
the Maintenance section.
3. Be sure that all nuts, bolts and
screws are securely fastened. In­
spect all visible moving parts for
damage, breakage and wear. Re­
place if necessary.
4. Touch up all rusted or chipped paint
surfaces: sand lightly before paint­
ing.
5. Cover the bare metal parts of the
blower housing auger and the im­
peller with rust preventative, such
as a spray lubricant.
NOTE: A yearly checkup or tune-up by
a Sears service center is a good way of
ensuring that your snow thrower will
provide maximum performance for the
next season.
ENGINE
A WARNING; Drain the gaso­
line outdoors, away from
fire or flame.
Gasoline must be removed or treated to
prevent gum deposits from forming in
the fuel tank, filter, hose, and carburetor
during storage. Also, during storage al­
cohol blended gasoline that uses etha­
nol or methanol (sometimes called
gasohol) attracts water. It acts on the
gasoline to form acids which damage
the engine,
F-001060J
1 . To remove gasoline, run the engine
until the fuel tank is empty and the
engine stops.
2. If you do not remove the gasoline,
use fuei stabilizer suppiied with unit
or purchase Craftsman Fuel Stabi­
lizer No. 3550. Add fuel stabilizer to
any gasoline left in the tank to mini­
mize gum deposits and acids. If the
fuel tank is almost empty, mix stabi­
lizer with fresh gasoline in a sepa­
rate container and add some to the
fuel tank.
3. Always follow the instruction on the
stabilizer container. After the stabi­
lizer is added to the fuel tank, run
the engine at least ten minutes to
allow the mixture to reach the car­
buretor.
4. Change the engine oil.
5. Lubricate the piston/cylinder area.
First, remove the spark plug and
squirt a few drops of clean engine
oil into the spark plug hole. Next,
cover the spark plug hole with a rag
to absorb oi! spray. Then, pull two or
three times on the recoil starter rope
to rotate the engine. Finally, install
the spark plug and attach the spark
plug wire.
OTHER
1. If possible, store your snow thrower
indoors and cover it to give protec­
tion from dust and dirt.
2. If the machine must be stored out­
doors, block up the snow thrower to
be sure the entire machine is off the
ground,
3. Cover the snow thrower with a suit­
able protective cover that does not
retain moisture. Do not use plastic.
IMPORTANT: Never cover snow
thrower while engine and exhaust areas
are still warm.
29