Before starting the engine, To start engine – Craftsman 917.28726 User Manual

Page 14

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

TOWING CARTS AND OTHER ATTACH­

MENTS

Tow only the attachments that are recom­

mended by and comply with specifications

of the manufacturer of your tractor. Use
common sense when towing. Too heavy
of a load, while on a slope, is dangerous.

Tires can lose traction with the ground and

cause you to lose control of your tractor.

SERVICE REMINDER/HOUR METER
Service reminder shows the total number
of hours the engine has run and flashes to

indicate that the engine or mower needs

servicing. When service is required, the
service reminder will flash for two hours.
To service engine and mower, see the

Maintenance section of this manual.
NOTE; Service reminder runs when the
ignition key is in any position but "STOP".
For accurate reading, be sure key remains
in the "STOP" position when engine is not
running.

BEFORE STARTING THE ENGINE

CHECK ENGINE OIL LEVEL

The engine in your tractor has been
shipped, from the factory, already filled
with summer weight oil.

1. Check engine oil with tractor on level

ground.

2. Remove oil fill cap/dipstick and wipe

clean, reinsert the dipstick and screw
cap tight, wait for a few seconds, re­
move and read oil level. If necessary,
add oil until “FULL mark on dipstick is
reached. Do not overfill.

• For cold weather operation you should

change oil for easier starting (See the
oil viscosity chart in the Maintenance
section of this manual).

• To change engine oil, see the Mainte­

nance section in this manual.

ADD GASOLINE

• Fill fuel tank to bottom of filler neck. Do

not overfill. Use fresh, clean, regular
unleaded gasoline with a minimum of

87 octane. (Use of leaded gasoline will

increase carbon and lead oxide deposits

and reduce valve life). Do not mix oil
with gasoline. Purchase fuel in quan­
tities that can be used within 30 days to
assure fuel freshness.

ACAUTION: Wipe off any spilled oil or
fuel. Do not store, spill or use gasoline

near an open flame.
IMPORTANT: When operating in temper­

atures below32°F(0°C), use fresh, clean
winter grade gasoline to help insure good
cold weather starting.

CAUTION: Alcohol blended fuels (called
gasohoi or using ethanol or methanol) can
attract moisture which leads to separa­
tion and formation of acids during storage.

Acidic gas can damage the fuel system

of an engine while in storage. To avoid
engine problems, the fuel system should
be emptied before storage of 30 days
or longer. Drain the gas tank, start the
engine and let it run until the fuel lines
and carburetor are empty. Use fresh fuel
next season. See Storage Instructions for
additional information. Never use engine
or carburetor cleaner products in the fuel
tank or permanent damage may occur.

TO

START

ENGINE

When starting the engine for the first time
or if the engine has run out of fuel, it will
take extra cranking time to move fuel from
the tank to the engine.

1. Be sure freewheel control is in the

transmission engaged position.

2. Sit on seat in operating position,

depress brake pedal and set parking
brake.

3. Move attachment clutch to disengaged

position.

4. Move throttle control to fast position
5. Pull choke control out for a cold engine

start attempt. For a warm engine start
attempt the choke control may not be
needed.

NOTE: Before starting, read the warm and
cold starting procedures below.
6. Insert key into ignition and turn key

clockwise to start position and release
key as soon as engine starts. Do

not run starter continuously for more

than fifteen seconds per minute. If the
engine does not start after several
attempts, push choke control in, wait
a few minutes and try again. If engine
still does not start, pull the choke con­
trol out and retry.

WARM WEATHER STARTING (50° F and

above)
7. When engine starts, slowly push choke

control in until the engine begins to
run smoothly. If the engine starts to
run roughly, pull the choke control out
slightly for a few seconds and then
continue to push the control in slowly.

• The attachments and ground drive can

now be used. If the engine does not
accept the load, restart the engine and
allow it to warm up for one minute using

the choke as described above.

14

Advertising