Craftsman 358.799400 User Manual

Page 3

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

ELECTRICAL SAFETY

^WARNING: Avoid a dangerous

environment. To reduce the risk of
eiectrical shock, do not use in rain, in

damp or wet locations, or around

swimming pools, hot tubs, etc. Do not

expose to snow, rain, or water to avoid

the possibility of electrical shock. Do

not handle extension cord plug or unit

with wet hands.

• Use only a voltage supply as shown

on the nameplate of the unit.

• Avoid dangerous situations. Do not

use in presence of flammable liquids

or gases to avoid creating a fire or ex­

plosion and/or causing damage to unit.

• Avoid dangerous environments. Do

not use in unventllaled areas or where

dust or explosive vapors can build up.

• To reduce the risk of electrical shock,

use extension cords specifically

marked as suitable for outdoor ap­

pliances. The electrical rating of the

cord must not be less than the rating

of the unit. The cord must be marked

with the suffix “W-A" (in Canada, “W”).

Make sure your extension cord is in

good condition. Inspect extension

cord before use and replace if dam­

aged. An undersized extension cord

will cause a drop In line voltage re­

sulting in loss of power and over­
heating. if in doubt, use the next

heavier gauge. The smaller the
gauge number, the heavier the cord.

(NOTE:

The correct size to be used

depending on the cord length is

shown in this manual. See

select

AN EXTENSION CORD in the AS­

SEMBLY section).

• inspect the insulation and connectors

on the unit and extension cord before

each use. If there is any damage, do
not use until damage is repaired by

your Sears Service Center. Do not

pull or carry by cord; do not use cord

as a handle, close a door on cord, or

pull cord around sharp edges or cor­

ners. Keep cord away from heated

surfaces. Do not unplug by pulling on

cord. To unplug, grasp the plug, not

the cord.

• To reduce the possibility of the exten­

sion cord disconnecting from the unit
during operation, secure cord to cord

retainer and connect to recessed plug

as shown in this manual.

• Do not use the unit if the switch does

not turn the unit on and off properly.

Have the unit repaired by your Sears

Service Center.

• Keep the extension cord clear of oper­

ator and obstacles at all times. Do not

expose cords to heat, oil, water, or

sharp edges.

• Avoid any body contact with any

grounded conductor, such as metal

fences, or pipes, to avoid the possibil­

ity of electric shock. Don’t handle plug

or unit with wet hands.

• Do not use with damaged cord or

plug. If unit is not working as it

should, has been dropped, dam­

aged, left outdoors, or dropped into

water, return it to your Sears Service

Center for repair.

» Ground Fault Circuit Interrupter (GFCI)

protection should be provided on the

circuit or outlet to be used for this unit.

Receptacles are available having built-

in GFCI protection and may be used

for this measure of safety.

• Keep others including children, ani­

mals, bystanders, and helpers a mini­

mum of 30 feet (10 meters) away.

Stop the motor immediately if you are

approached. Do not allow the unit to
be used as a toy.

DOUBLE INSULATION
CONSTRUCTION

This unit is double insulated to help

protect against electric shock. Double

insulation construction consists of two
separate “layers" of electrical insula­

tion instead of grounding.
Tools and appliances built with a

double insulation system are not in­

tended to be grounded. No grounding

means is provided on this unit, nor

should a means of grounding be add­

ed to this unit. As a result, the exten­

sion cord used with your unit can be

plugged into any standard 120 volt

electrical outlet. Safety precautions

must be observed when operating any

electrical tool. The double insulation
system only provides added protection

against injury resulting from an internal
electrical insulation failure.

WARNING: All electrical repairs

to this unit, including housing, switch,

motor, etc., must be diagnosed and re­
paired by qualified service personnel.
Replacement parts for a double insu­
lated appliance must be identical to the
parts they replace. A double insulated
appliance is marked with the words
“double insulation" or “double insu­
lated”. The symbol (square within a
square) may also be marked on the
appliance. Failure to have the unit re­

Advertising