Craftsman 358.799400 - Manual (Page 8)

heating can occur causing damage
to unit. Refer to table for minimum
wire gauge recommendations. The
cord must be marked with the proper
wire gauge. (Appropriate extension
cords are available.) Do not use mul­
tiple cords.
in good condition. Cord insulation
must be intact with no cracks or
deterioration. Plug connectors must be
undamaged,
do not use multiple
cords.
MINIMUM WIRE GAUGE
RECOMMENDATIONS
VOLTS 25 FT. 50 FT. 100 FT.
120 16 16 14
AW.G.* A.W.G.* A.W.G.*
^American Wire Gauge
Secure the extension cord to the unit by
threading the cord through the arrd re­
tainer (see lilustration). Insert the cord
receptacle into the recessed plug.
OPERATION
KNOW YOUR ELECTRIC BLOWER
READ THIS INSTRUCTION MANUAL AND SAFETY RULES BEFORE OPERATING YOUR
UNIT.
Compare the illustrations to your unit to familiarize yourself with the location
of the various controls and adjustments. Save this manual for future reference.
The ON/OFF SWITCH is used to
activate the motor.
INLET COVER LATCH
The INLET COVER LATCH is used to
open and close the inlet cover and to
secure the upper vacuum tube to the
blower unit.
BLOWER TUBE
The BLOWER TUBE is designed to di­
rect the flow of air.
The INLET RESTRICTOR improves the
blower function.
TUBE RELEASE BUTTON
The TUBE RELEASE BUTTON secures
the blower tube or elbow tube to the
blower unit during operation. Also,
pressing the tube release button allows
removal of the blower tube or elbow
tube.
8